4.5. Positioning the panoramic curve
4.5. Positioning the panoramic curve
The panoramic curve (the middle of the three curves which appear in the axial view) should be positioned to pass through the middle of the patient’s ridge.

This can be done by using the slider (1) to identify an axial slice which shows the complete arch/ridge of the patient’s jaw. If necessary, it is possible to switch the display mode of the axial slice to an X-ray display by clicking button (2).
The curve as a whole can be shifted by dragging point (4), and the local form can be adjusted by dragging any yellow square (5). Dragging the yellow circle within the curve decreases/increases the curve.
Alternatively the entire curve can be redrawn by pressing the “Edit Dental Curve” button (3). The user can left-click periodically as the mouse moves around the arch (from left to right), placing dots. The software will connect the dots to draw the panoramic curve. Be sure not to double back over a section of the curve which is already drawn, as this will create inconsistencies in the curve. When the curve is complete just click on the “Edit Dental Curve” button (3) again, or press “Esc”.
Back to Content Page
Previous Page 4.4. Scan alignment and defining the range of slices
Next Page 5. Software interface