21.8. Step 1 – Undercuts and insert direction
21.8. Step 1 – Undercuts and insert direction
Step 1 is used to define the initial parameters for the denture.

The sliders can be used for setting the values for offset and undercut removal.
The insert direction should be adjusted using the rotation ring so that the undercuts are minimised.
“Set insert direction from view” is used to set the insert direction according to the current viewing angle setting.
“Reset insert direction” will restore the original status of the arrow and the model.
“Define posterior palatal seal” permits the modelling of this structure. The Palatal Seal is created by left clicking with the mouse on the two required points with Shift key pressed. Adjustments can be done by drawing with the mouse.

The “Back” and “Next” buttons are used for moving one step back or forwards.
Back to Content Page
Previous Page 21.7. Create denture
Next Page 21.9. Step 2 – Select denture base