19.3. Model upload and preparation
19.3. Model upload and preparation
In the next step the model will be uploaded and prepared. Depending on the surface scan import type, several preparatory steps may be run before you get a model prepared for aligning with the DICOM data.
· Model STL - simply upload.
· Model CT - it is necessary to set the surface threshold and create a surface model.
· Impression CT - it is necessary to first set the surface threshold and create an impression model. Then you must plot and edit a curve in the impression model delimiting the appropriate model part (see figure below) and create an inverted model.
· Impression CT with Markers – you need to align the scan appliance with the gutta percha markers (refer to section 7) and then, as in the case of the Impression CT, create an inverted model.

Back to Content Page
Previous Page 19.2. Adding a mandibular canal
Next Page 19.4. Model aligning