14. Tooth segmentation
14. Tooth segmentation
Blue Sky Plan® makes it possible to segment and remove individual teeth from the data. The following two segmentation methods are supported.
With a correctly set dental curve it is possible to select a tooth by clicking (1) on the data in one of the orthogonal slices. The result of the selection will be colored in (7) in all the slices. The result of the automatic segmentation can be corrected with the "Height Limit" parameter (2) which determines the distance from the slice up to which the program should attempt to detect the tooth. By reducing this, it is possible to compensate for erroneous detection in an area where the tooth is difficult to differentiate from the bone automatically.

If automatic delimitation of the tooth fails, it can be selected in the data using the virtual tooth manually positioned in the data via the “Virtual Teeth > Add Tooth“ option from the main menu. After positioning the model, perform the “Use Active Tooth Model” action (3) for the designated data on the basis of the tooth model entered. Using the "Model Neighbourhood Parameter" (4) you can perform a slight correction of the area around the positioned model which is selected.
It is possible to transfer the area of the tooth marked in the data into the model by clicking “Create Surface” (5). The model created in this way appears in the “Surfaces” panel in the “Imported Surfaces” table.
The tooth can be removed from the data by clicking “Remove Tooth” (6). If you are not satisfied with the result, the action performed can be reversed with the "Undo" button, and the tooth selection parameters can be modified.
Back to Content Page
Previous Page 13.4. Context menu
Next Page