The air around you began to heat as lava surged from the grates in the central forge, quickly filling it with molten fire. Then, the central column began to rise—before slamming down into the lava with immense speed. It repeated this process again and again, each time rising about 30 feet above the forge before crashing back down, creating deep, reverberating, ear-piercing booms that echoed through the chamber.
Suddenly, from high above, eight fiery beams of scorching light shot down from the ceiling, piercing into the lava and heating it further until it glowed a light, almost ethereal blue. Still, the column rose and fell, over and over, in a relentless rhythm.
Then—without warning—the blue lava erupted into a frenzy of red-hot flames, engulfing the entire forge in fire. The air now burned against your skin, the heat almost unbearable.
From the points where the eight beams originated, a single, enormous beam of the same fiery light blasted downward, striking the heart of the forge. The lava churned furiously beneath it.
Moments later, a thick white foam burst from the floor, filling the chamber and completely obscuring your vision. When the foam finally settled, clumps of it clung to the floor, slowly dissolving. But now, the air had cooled—drastically.
The screen is the control panel of the forge. It displays instructions on its screen for what to do and contains various buttons to do tasks (Eject mold, Release coolant, Trigger Alarm, Emergency Shutdown Procedure) and a small poutruding slit, perfectly sized for a stone tablet.
Beside the screen is a lever that, when everything is done can be pulled to activate the forge. The forge works almost automatically (because of the immense heat) based on special instructions written on stone tablets.
To activate the forge first input a stone tablet with instructions into the screen:
The screen will give 2 instructions: Load Mold and Pull lever
Load the mold into the slot in the bottom column in the central pit (the forging area of the forge)
Pull the lever and get behind cover
After the forging is compleat the new instruction on the screen is: remove mold. This can be accomplished by making a DC 35 strength check on removing the mold, or by pressing the “eject mold” button on the screen and then succeeding a DC 10 strength check to pull out the mold.
The stone tablets have precise instructions on them, but to any uninformed reader it appears as a jiberish of random words (its basically code) followed by a bunch of numbers: these numbers are parameters for various instructions and components.
To make a new instruction you must be versed in the craft, few still know how to make instruction tablets: Adaranth and the remaining forger dwarfs at Goliath’s Strong Vault
-7121 YB - Construction on the Forge began
-6119 YB - Construction on the Forge concluded
-4602 YB - Forged the ‘Dream Blade’ for Adaranth
-4587 YB - Began plans for the construction of Goliath’s Strong Vault
-2363 - Completed construction of Goliath’s Strong Vault; Most Grim Dwarfs left the forge at this time to continue to improve the Goliath’s Strong Vault
The forge was built from the dead corpse of a dead god killed in the God Purge